BETAFPV 2S F4 FC Brushless Flight Controller ESC OSD Smart Audio, Great F4 FC+ESC Stack for your 2S whoop! X-series Beta75X and Beta65X

I requested this fc and esc combo for my brushless very small whoop project. I was wanting for a f4 brushless combo that would in good shape inventory mounting of a tinywhoop body and this fits like a glovethe esc and fc can tackle 2s, eight. Operating 19,000kv motors and this combo pushes electricity with out an problem.Extraordinary high-quality command at manufacturing facility ensuing in doing work products and solutions from the instant you open up the boxthe combo does not sit tall inside the tiny whoop body incase that was an challenge you ended up fearful about, you cant even notify it’s two piecesthe fc has all the ports essential for all the newest betaflight features. Lots of uarts for tbs crossfire and smart audio. Exact same timecomes pre programmed from factory with pids previously established for great manufacturing facility flight100% well worth the income and it gives you with unmatchable power and high-quality to any other brushless whoop item.

This fc+esc combo is fantastic for developing a 2s brushless whoop like the beta75x or beta65x. It connects to a conventional whoop design and style frame so you can use it in lots of frames. ability direct (65x stock set-up) but you can also get it with a xt-30 connector (stock 75x set-up). Examine out the betafpv web pages for much more facts on set up.

Got this f4 fc and it was seriously simple to setup. I like how it is practical to take out the stack. I am applying a betafpv camera as perfectly. So significantly so excellent, it was an simple build.

I got it all related and doing work after numerous several hours but i’ve discovered my vtx heating up a peculiar sum. I ponder if i just hardly ever recognized right before or if a thing could possibly be improper.

Key specs for BETAFPV 2S F4 FC Brushless Flight Controller ESC OSD Smart Audio (No RX) with XT30 Cable for 2S Brushless FPV Whoop Drone Beta75X Beta65X:

  • Make sure this fits
    by entering your model number.
  • The F4 2S brushless flight controller and ESC built-in BetaFlight OSD is customized for 2S whoop drone like Beta75X and Beta65X. Please note: When you connect the receiver to this 2S FC, don’t forget to plug the battery, otherwise the receiver will have no power to work at all.
  • This combo F4 2S FC with ESC is customized to work with 2S 350mAh battery for Beta75X, which will bring your drone a nice punch. If you want to use it with your own 1S whoop battery, please change the cable to JST-PH2.0 — https://www.amazon.com/dp/B07GXBF8VN.
  • Please note this F4 2S FC is built without receiver, but all the ports are available on this board, you could connect any receiver you want, like Frsky, TBS or DSMX Receiver, and Buzzer solder pads is also available. Receiver Connection: https://betafpv.freshdesk.com/support/solutions/articles/27000049913-f4-2s-brushless-fc-esc
  • Firmware version of F4 FC is Betaflight OMNIBUSF4SD (OBSD), Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode). Support TBS micro receiver with TX02, RX02 ports. RSSI ports is available. Any technical support needed please contact: [email protected]
  • This ESC support BLheli/BLHELI_S suite Pass-through ready, support PPM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600.It can fit motors with 1.5mm header pins connector like 0703, 0603,1103 motors etc, and you can use it work with the 1pcs 2S 300mAh battery or 2pcs 1S 260mAh battery.

Comments from buyers

“Brushless whoop powertrain!!!!
, Easy to build FC!
, VTX Is heating up severely

Summary
Review Date
Reviewed Item
BETAFPV 2S F4 FC Brushless Flight Controller ESC OSD Smart Audio (No RX) with XT30 Cable for 2S Brushless FPV Whoop Drone Beta75X Beta65X
Rating
4.1 / 5  stars, based on  4  reviews